MOVENTUR “DRIVE editions
have an M” logo
engraved in the crown.
DRIVE POSITION MARKER
When revolving the watch case into drive
position an engraved “DRIVE” will appear on the
left side of the case.
This feature works for both left and right hand use.
The design of our case back is lowered into the case so it can’t be felt on the wrist making the watch more comfortable to wear with both nylon or leather straps.
All MOVENTUR watches have the specifications and limited edition number engraved on the case back.
HOW TO ATTACH OUR NATO STRAPS TO YOUR
HOW TO ATTACH
OUR SUEDE LEATHER STRAPS
TO YOUR MOVENTUR DRIVE
Carefully unscrew the 2 small through screws between the horns of the watch with the small screwdriver that comes with all DRIVE Edition watches.
Place the leather strap between the watch's horns. Using your fingers, carefully push the screws through the screw hole and the inner metal tubes in the strap. Push the screws in until you feel that the screw is in the threaded hole on the opposite horn. Correctly placed, you will hear a small "click" and notice that the screw cannot tilt. Then carefully tighten the screws with the screwdriver, and you are done.
If the screw seems the least bit tight, then it is not seated properly in the thread. Therefore, unscrew it a little again and gently press it back in with a finger. Correct placement makes the screw easy to screw in.
Never use force to screw in the screw.
This can damage the thread beyond repair.
CLEANING YOUR MOVENTUR
Before cleaning your MOVENTUR DRIVE, always check that the crown is fully screwed in.
Rinse the watch under cold, running tap water. If it is dirty or
greasy, you can also use a small amount of mild dish soap. If the turning function of the watch feels a little tight, it could be because there is some dust trapped inside the opening of the watch case. In most cases, you can blow this away with your mouth or remove it with running tap water while you turn the dial back and forth at the same time.
Never lubricate the rotating function of the watch with oil or anything else. It will destroy
the turning function of the watch.